HWS-802HW Constant Heat Wheel Sealer with 5mm Seal

HWS-802HW Constant Heat Wheel Sealer with 5mm SealGreat for irregular size packagingSuited for sealing thicker materialsEquipped with a convenient rack to hold sealer when not in useTemperature can be regulated from 150oF to 360oF with a quick turn of the knobTemperature controller contains on/off switch with safety lightSealing wheel is PTFE coated with an embossed design and makes 1/4" (5mm) on the 802 model and 3/8" (10mm) on the 803 modelSafety shield protects user from accidentally touching the hot wheelProtective rubber mat includedAll metal constructionWarm up time required (5-10 minutes)Unit can be used for cut and seal applications by angling at a 45 degree angleHWS-802HW and HWS-803HW are constant heat hand wheel sealers that seal plastic material in any configuration with a 5mm or 10mm seal width. Simply place the PTFE coated wheel along the material whether the material is polyethylene or cellophane. These versatile sealers can make round, oval, square or any unique shape with a textured mesh seal.Easy to OperatePlace the unit on the rack and plug into an outlet. Turn on the temperature control knob to the setting that seals the material. Allow the unit to heat up for approximately 10 minutes. Place the material to be sealed on the heat resistant rubber mat and roll the hand wheel across the material. Note: A few trials may be necessary to determine the correct temperature setting and speed.Hints for Best ResultsAlways use the smooth heat resistant rubber mat or corrugated cardboard under the material to be sealedNever seal on glass, paper, or woodRoll the hand wheel slowly and steadily over the material to be sealedAvoid pressing down too hard or rolling too fastAdjust the temperature and/or speed to get the desired sealReplace the hand wheel sealer on the rack when finished sealingTurn off the switch when sealing is completedIf you want a "seal & cut" type of seal, turn the unit so that only the wheel edge comes in contact with the plastic materialAlways remove any bits of accumulated plastic from wheel by using a dry cloth or soft brushAlways unplug the unit before performing any maintenancePower Supply: 120V, 60HzStand Weight : 6oz.Watts : 70WPower Cord Length : 6ft.Seal Length : UnlimitedRubber Mat : 11 ¾” x 11 ¾” x 1/16”Seal Width : 5mm / 10mmMaterial Thickness : 10milHand Wheel Weight : 13oz.Temperature Range:150⁰F - 360⁰F(65⁰C - 180⁰C)